Analyzing mechanical behavior of ABS-SiO2 polymer-based nanocomposite based on anova method
Mohammad Afzali, Vahid Asghari
Quarterly No. 3, 2021 pages 61-69
DOI:
keywords: acrylonitrile-butadiene-styrene, nano-silica, extrusion, RSM, tensile strength, impact toughness, fatigue behavior
abstract The fabrication of polymer-based nanocomposites by means of twin extruders is a typical method for manufacturing lightweight and high-strength structures. However, selection of the optimal parameters for this process to study the material characteristics is important. The primary aim of the present study was to ascertain the optimum extruder temperature and nanosilica content in an acrylonitrile-butadiene-styrene matrix composite. The response surface methodology was based on two factors and three levels. The identification of the effect of the parameters on the fatigue behavior of the fabricated composite was comprehensively analyzed. The results were analyzed using scanning electron microscopy (SEM). The obtained results revealed that up to 4% nano-SiO2 improves tensile strength and reduces the impact toughness. On the other hand, an increase in the extrusion temperature yields a higher impact toughness and lower tensile strength. The optimization results showed that 2.5% nanosilica and the extrusion temperature of 225°C result in the maximum tensile strength of 41 MPa, and impact toughness of 30 KJ/m2.The fabrication of polymer-based nanocomposites by means of twin extruders is a typical method for manufacturing lightweight and high-strength structures. However, selection of the optimal parameters for this process to study the material characteristics is important. The primary aim of the present study was to ascertain the optimum extruder temperature and nanosilica content in an acrylonitrile-butadiene-styrene matrix composite. The response surface methodology was based on two factors and three levels. The identification of the effect of the parameters on the fatigue behavior of the fabricated composite was comprehensively analyzed. The results were analyzed using scanning electron microscopy (SEM). The obtained results revealed that up to 4% nano-SiO2 improves tensile strength and reduces the impact toughness. On the other hand, an increase in the extrusion temperature yields a higher impact toughness and lower tensile strength. The optimization results showed that 2.5% nanosilica and the extrusion temperature of 225°C result in the maximum tensile strength of 41 MPa, and impact toughness of 30 KJ/m2.